The Following design optionsare available on nearly all models of MSI's amplifier Lines.If any of the below options are desired, the corresponding suffiixlisted below should be added to the end of the amplifier model # |
-AGC Automatic Gain Control is available to increase
the dynamic range in a wide variety of microwave
systems. AGC can be controlled by manual control,
voltage control, or binary input.
-FIL Filters can be integrated into the amplifier to attenuate
adjacent or harmonically related signals. Types of filters
available include Bandpass, Highpass, and Lowpass.
-LIM Limiters can be included to protect input stage from
CW signals to 25 dBm typical.
-TC Temperature Compensation is used to reduce gain change
None Hermetic Sealing is laser welding available for hermeticity,
to be used primarily for compliance with military standard
MIL-STD-8883 method 1014 for fine and gross leak testing.
None Coupled Ports are auxilliary output ports which can be
included for power measurements, monitoring, and for
-DET Internal RF detectors can be included for output power level
-TTL Digital TTL levels are used to place amplifier in stand-by mode,
to reduce power consumption, and to provide better isolation.
-BIT A warning indicator as a Built In Test is used to signal
catastrophic failure in an amplifier by monitoring device current.
-PS A Power Supply is incorporated into an amplifier to accept a
wide variety of input voltages.
-RM Rack Mounted casings are available for most of MSI's model
amplifiers. These units include AC/DC power supply, forced
cooling if requierd, AC line filtering, and circuit breaker.
-C A Class C amplifier is one which does not require linear power
-WW Specifies Waveguide input and output connectors.
-NN Specifies N-Type input and output connectors.
-DI Specifies Drop-In amplifier package.
MICROWAVE SOLUTIONS, INC.®
3200 HIGHLAND AVE. SUITE 300
NATIONAL CITY, CA 91950
TEL: (619) 474-7500 FAX: (619) 474-7003
©2005 Microwave Solutions, Inc.®
All rights reserved.